PixKit

Home / All Tools /Utility

Color Blindness Simulator

See an image through protanopia, deuteranopia, tritanopia and achromatopsia, drag a divider to compare, and read the colour distances that collapse.

✓ Local processing · No uploads · No signup

Drop an image, or click to browse

Simulates protanopia, deuteranopia, tritanopia and achromatopsia; drag the divider to compare

Real-world uses

  • A dashboard shows up/down in red and green: under deuteranopia both collapse into the same muddy yellow-brown with a single-digit colour distance. Recolour to blue and orange and the distance jumps by an order of magnitude — legible to colour-blind readers.
  • Five status colours in a design look suspiciously close: the panel names the closest pair with its distance, which reflects how they read in the actual artwork rather than calculating ideal swatches one by one.

Limits: Simulation uses the Machado / Oliveira / Fernandes (2009) matrices at severity 1.0, i.e. full dichromacy — most real cases are partial and see less difference than shown. The matrices apply in linear-light RGB; multiplying sRGB values directly gives visibly lighter shadows. Colour distance is an OKLab distance scaled to 0–100: under 2 is effectively indistinguishable and under 10 is ambiguous, an empirical guideline rather than a clinical test. Only the exported copy is altered.

Related tools:Check one colour's contrastReplace the clashing colour

How it works

  1. Drop an image — it opens in deuteranopia, the most common red-green type
  2. Switch between protanopia, deuteranopia, tritanopia and achromatopsia, and drag the divider to split original against simulation
  3. Read the swatch panel: any two colours that collapse into each other are called out, then export the simulated image

FAQ

How accurate is the simulation?

It uses the physiological model published by Machado, Oliveira and Fernandes in 2009 at severity 1.0 — full dichromacy, where one cone type is absent. It is the most widely cited public model and underlies most browser simulators. The difference is that many implementations multiply the matrix against sRGB values directly, which lifts the shadows; here the values are linearised first.

Why is there no severity slider?

Because the question is whether any reader will fail to tell the colours apart, and that is decided by the worst case: a fully dichromatic reader sees this setting. A severity slider invites negotiating the verdict — colours failing at 0.5 does not make them fine at 1.0, it just understates the problem.

How do I read the colour distance?

The distance is measured in OKLab between the two simulated colours, then scaled to 0–100. Under 2 is below the just-noticeable difference, under 10 can be told apart when side by side but is ambiguous at a glance, and above 10 is generally safe. Lower means riskier, and the closest pair is named for you.

Related tools